Filter
Top Products
Auto Upgrade 65
SmartLink M-ATA Getting Started Guide 6 • System
Auto Upgrade
The SmartLink M-ATA family includes a configuration and firmware download manager server that allows for
the updating of large numbers of SmartLink M-ATAs from a central location. By factory default, all SmartLink
M-ATA units are set with auto-update on and to access the Patton auto-update server. Many of Patton’s car-
rier customers have chosen to setup their own auto-update server to provide service specific information for
their end users. Patton recommends that end users do not change the auto-update server or set “Enable auto-
upgrade” to “NO” without consulting with their service provider.
Figure 41. AutoUpgrade window
Routine Upgrade every xxx day(s)
If selected, the SmartLink M-ATA will check for automatically check for updates at system reload time and on
a periodic basis based on the number of days selected.
Enable Auto Upgrade
Enable or disable auto upgrade—If enabled, the SmartLink M-ATA will automatically check the upgrade
server for new system firmware and software upon reload, power cycle, or when the routine upgrade
interval expires.
Auto Upgrade Protocol
Select the protocol for auto upgrade
Upgrade Server
Specify the auto upgrade server IP address
Auto Upgrade URL
Specify the auto upgrade server by URL. This field is dependent on the auto upgrade service package installa-
tion. The default value is iadmgr.
Saving your work
When you are finished configuring settings, click the Save AutoUpgrade button to save the changes.