Filter
Top Products
Feed Mode
You can use continuous or on-demand printing. On-demand
printing allows you to remove a label before printing the next one.
To change the setting, from the Main Menu, select Setup, then
Supply. Then, follow these steps.
1. Press L or R until you see
SUPPLY
l Feed Mode r
2. Press E to set the supply type option. You will see the
current setting, for example:
SUPPLY TYPE
Continuous r
3. Press L or R to see the other option. After you display the
option you want, press E. Press e twice to exit to the
Main menu.
Print Position
This function adjusts where data prints vertically on the supply.
Adjust the print if it is too close to the top or bottom of the supply,
or overtypes the pre-printed area. One dot is 0.0049 inch.
◆
If the data is too close to the bottom, increase the number.
◆
If the data is too close to the top, decrease the number.
Changing this setting only affects new
formats sent to the printer.
2-4 Setting Supply Options