Filter
Top Products
B6. cut_posn -99 to 99 in 1/203 inch. Use 0 for these printers.
Example {I,B,0,0,1,10,0 p }
Indicates black mark and thermal direct stock has been loaded,
causes the printer to operate in on-demand mode and feeds the
supply approximately .05 inches up before printing the format on
each label (10/203 inches).
Defining the Print Control Packet
Use the print control packet (C) to set the contrast, print, and
margin adjustment, print speed, and printhead width.
Syntax
{I,C,contrast,print_adj,margin_adjust,
speed_adj,ph_width p }
C1. C Print Control Packet
C2. contrast -390 to 156. 0 is the default for all printers.
C3. print_adj -99 to 99 in 1/203 inch. 0 is the default for all printers.
Adjusts where data prints vertically on the supply. Increase
the print position to move print up, decrease to move print
down.
C4. margin_adj -99 to 99 in 1/203 inch. 0 is the default for all printers.
Adjusts where data prints horizontally on the supply. Increase
the margin position to move print to the right, decrease to
move print to the left. Margin and print position are format
adjustments. They will not affect the supply position.
C5. speed_adj Print speed. Use 0 for these printers.
C6. ph_width Width of the printhead in dots. Use 0 for these printers.
Example {I,C,0,-20,-10,0,0 p }
Uses the default contrast, moves print 0.1 inch closer to the
bottom of the supply (20/203 inches) and .05 inch to the left on
the supply (10/203 inches), prints at two inches per second, and
uses the default printhead width.
Configuring the Printer 3-11