Filter
Top Products
Re-Loading or Changing Supplies
If you run out of supplies while printing, the printer display or
keyboard shows a 756 status code.
1. Press the Feed button to feed the last tags into the stacker.
2. Load a new roll of supplies. For more information on loading
supplies, refer to the printer’s Operator’s Handbook or
Quick Reference.
If you are switching to a different supply type,
you will need to reset the belt speed.
See Chapter 1.
3. Press the Escape button to clear the status code.
4. Press the Feed button (once or several times, depending on
the tag’s length) to feed a tag through the knife and into the
stacker tray.
5. Continue printing.
Emptying the Stacker
You can empty the stacker while it is running, or wait until it is full.
When the stacker is full, a sensor at the end of the tray stops the
printer. The printer or keyboard shows a 761 status code on the
display.
Stacker Full
1. Empty the stacker tray.
2. Place the tag weight against the tag stop.
3. Press the Escape button on the printer to clear the status
code.
4. Continue printing.
2-2 How to Operate