Filter
Top Products
8 C4680M-A (8/11)
Before You Begin
Endura is a network system that requires a continuous amount of bandwidth to transmit live video; therefore, always include your network
administrator when planning and installing Endura components.
You will also need the following items:
• Pelco-approved Endura certification if you are installing an SM5000 system manager or NSM5200 network storage manager.
• Access to an Endura network
– that is an active, gigabit Ethernet network that supports the full Internet Protocol suite,
– that is configured with at least one SM5000 system manager
PRODUCT SERIAL NUMBER LABEL PLACEMENT
The product serial number label helps identify your universal device interface and its factory configuration settings in the event that the unit
requires service.
A label citing your product’s serial number is attached to the bottom panel of the universal device interface. Because rack mounting or other
installation options may obscure the factory-applied label, two additional labels are provided. Attach one label to your product documentation or
another product location that will not be obscured by installation. The second label is a spare.
To use the serial number label, complete the following steps:
1. On the bottom panel of the universal device interface, locate the two small labels, attached with a yellow sticker that reads “Extra serial
number labels: remove prior to installation.”
2. Remove the yellow sticker and the labels.
3. Peel away the backing from one label and attach it to this manual, other product documentation, or an unobscured product location.
Figure 3. Product Serial Number Label
MODEL
FREQ
Sample TextSample Text
AMPS
VOLTS
Sample Text
REV
Sample Text
03267-39-0020
MFG BY PELCO, CLOVIS, CA
Model
SN
MADE IN USA