Filter
Top Products
C4680M-A (8/11) 9
Installation
MOUNTING
Use one of the following installation methods for the universal device interface (detailed instructions are provided in the following sections):
• Desktop installation: The UDI5000 Series is equipped with rubber feet for placement on a flat surface, such as a shelf or desktop.
• Rack mount installation: Turn the unit upside down and remove the four rubber feet from the unit. The feet are attached with screws.
Store the screws and feet for future use. Install the unit in the optional RK-UDI5000 rack mount kit.
DESKTOP INSTALLATION
When placing the universal device interface on a flat surface, such as a desktop, be sure that you position the unit to allow for cable and power
cord clearance at the rear panel.
Figure 4. UDI5000 Series Desktop Placement
RACK MOUNT INSTALLATION
You can mount the UDI5000 Series in the optional RK-UDI5000 rack mount kit along with a second unit. The rack mount kit is designed to support
two UDI5000 Series units in a side-by-side installation. For installing a single unit, the rack mount kit contains support brackets that can be
attached to the UDI5000 Series before installing it in a rack. The UDI5000 Series connects directly to a power brick that rests in a shelf at the
back of the mounting kit. Clearance for power cords is provided for up to two units in the rack.
Refer to the rack mount installation manual for instructions.
HARDWARE CONNECTIONS
NETWORK CONNECTION
Consult your network administrator before installing the universal device interface to avoid possible network conflicts.
Use the network port on the rear panel and a Cat5e (or better) cable with RJ-45 connectors to connect the universal device interface to your
system network.
Figure 5. Network Connections
WARNING: Do not place the universal device interface on its side; the unit could fall over and cause equipment damage or personal injury.
RJ-45