Filter
Top Products
14 Pelco Manual C581M-B (1/04)
Table B. Operation Guide (Continued)
1. Press the MAIN MONITOR key. The green LED over the
MAIN key lights.
2. Select a camera on the multiplexer that you want to
sequence.
Addressing by Multiplexer (Switch 7 OFF)
a. On the number pad, press the address number of the
multiplexer (1-16 if the keyboard is connected to a
multiplexer; 1-8 if the keyboard is connected to a
server), then press the UNIT key. The LED displays
the address.
b. On the number keypad press the number of a
camera (1-16), then press the CAM key.
Addressing Consecutively (Switch 7 ON)
On the number keypad press the number of a camera,
then press the CAM key. Refer to Table C for camera
numbers.
3. Press the LIVE/VCR key to select the mode of
operation.
4. To sequence individual cameras, go to step 5. To
sequence groups of cameras, press the key below the
4- or 9-screen icon, then go to step 5.
5. Press the SEQ key.
1. Press the SPOT MONITOR key. The green LED over
the SPOT key lights.
2. Select a camera on the multiplexer that you want to
sequence.
Addressing by Multiplexer (Switch 7 OFF)
a. On the number pad, press the address number of the
multiplexer (1-16 if the keyboard is connected to a
multiplexer; 1-8 if the keyboard is connected to a
server), then press the UNIT key. The LED displays
the address.
b. On the number keypad press the number of a
camera (1-16), then press the CAM key.
Addressing Consecutively (Switch 7 ON)
On the number keypad press the number of a camera,
then press the CAM key. Refer to Table C for camera
numbers.
3. Press the SEQ key.
1. Press the MAIN or SPOT MONITOR key.
2. On the number pad, press the address number of the
multiplexer (1-16 if the keyboard is connected to a
multiplexer; 1-8 if the keyboard is connected to a
server), then press the UNIT key. The LED displays the
address.
3. Press the SEQ key.
OPERATION KEYBOARD COMMAND RESULT
Starts the sequence of individual
cameras on the SPOT monitor.
Stops the sequence. The monitor
displays video from the camera on
which sequence stops.
Run a sequence of
cameras from one
multiplexer on the
SPOT monitor. (SPOT
MONITOR DISPLAY in
the Advance System
Setup menu must be in
SEQUENCE.)
Stop a sequence of
cameras on a
multiplexer.
(Continued on next page)
Run a sequence of
cameras from one
multiplexer on the
MAIN monitor.
Starts the pre-programmed
sequence of individual cameras or
groups of cameras on the MAIN
monitor.