Pelco C581M-B Computer Keyboard User Manual


 
Pelco Manual C581M-B (1/04) 9
2. If you have more than one multiplexer, each one must have its own address (Unit ID in
the Advanced System Setup menu). If you have a server, the multiplexer address
must match the input on the server to which it is connected; for example, if the multi-
plexer is connected to input 3 on the server, set the multiplexer address to 3. Set the
address from the front panel of the multiplexer, not from the key-
board.
3. If you have moveable cameras (they must be Coaxitron compatible), you must pro-
gram the Coaxitron format for each camera (Camera menu). The duplex multiplexer
COAXITRON FORMAT default setting is OFF, while the simplex default setting is
EXTENDED. Programming can be done from the front panel of the multiplexer or from
the keyboard (refer to the
Programming
section for keyboard instructions).
MULTIPLEXER SERVER
Below is the minimum you should check.
If you intend to control two monitors from one keyboard (paired mode), you must change
the settings for the monitors (Monitor menu). Programming the server can only be done
from the keyboard. Refer to the server manual for instructions.
IMPORTANT NOTE ABOUT COAXITRON
CONTROL OF CAMERAS
The KBD4002 keyboard provides Coaxitron
control of pan, tilt, and lens functions.
The duplex multiplexer COAXITRON FORMAT (refer to the
Camera Setup
section)
default setting is OFF and must be changed in order to use Coaxitron control. The
simplex multiplexer default setting is EXTENDED and 32-bit Coaxitron control can be
used without changing the setting.
When used with 15-bit standard Coaxitron
receivers, such as the CX9000 Series, the
PT7700, and the ED25/27/28/29, the KBD4002 supports all pan, tilt, and lens functions,
and AUX on/off. The keyboard will not set or call presets or support preset scanning.
When used with 32-bit extended Coaxitron
receivers, such as Esprit, Intercept
,
Spectra, and LRD41C21/LRD41C22 Series, the KBD4002 will support all the functions
above, including the setting and calling of presets and patterns. It will not support
programming of preset or pattern labels. If labels for presets or patterns are required, they
would need to be programmed with a different control, such as the MPT9500.
IMPORTANT NOTE ABOUT DIFFERENCES IN SIMPLEX AND
DUPLEX MULTIPLEXER MODES OF OPERATION
The simplex multiplexer has three modes of operation: live, VCR, and record.
In the live mode, the main monitor can show live video both in full-screen or
multiple-screen views. You cannot record in the live mode. The multiplexer’s
DISPLAY/RECORD LED is OFF.
In the VCR mode, the main monitor will show full-screen or multiple-screen views of
videotape playback. You cannot record in the VCR mode. The multiplexer’s DISPLAY/
RECORD LED is OFF.
In the record mode, the main monitor will show live video of an individual camera in
full-screen view only. You can record only when in the record mode. While recording,
all cameras are being recorded simultaneously. The multiplexer’s DISPLAY/RECORD
LED is ON.
The duplex multiplexer has two modes of operation: live and VCR.
In the live mode, the main monitor will show live video both in full-screen or
multiple-screen views. You can record while in this mode. The multiplexer’s LIVE/VCR
LED is ON.
In the VCR mode, the main monitor will show full-screen or multiple-screen views of
videotape playback. You can record in the VCR mode if you have a second VCR con-
nected to the VCR OUT jack on the multiplexer. The multiplexer’s LIVE/VCR LED is OFF.