Filter
Top Products
C1552M-C (7/07) 39
CM9760-REL RELAY INTERFACE UNIT
To connect a CM9760-REL relay interface unit to the VMX300(-E), complete the following steps (refer to the CM9760-REL Installation/Operation
manual for detailed instructions):
1. Connect the relay unit to the VMX300(-E) as described below for the appropriate communication mode:
Direct serial: Connect an RS-232 to RS-422 adapter to COM 1 or COM 2 on the VMX300(-E) workstation, and then wire the adapter to a
wall block (user-supplied), as shown in Figure 37. Using an RS-422 reversed data cable, connect the wall block to the IN port on the
CM9760-REL.
Figure 37. CM9760-REL Direct Serial Connection
Internet Protocol: Connect the RS-422 IN port on the relay unit to an RS-422 serial port on a networked device, such as a PelcoNet
encoder. If the networked device does not have an RS-422 serial port, use an RS-232 to RS-422 adapter. (Refer to Figure 26 on page 28 for
a sample illustration.)
2. (Optional daisy-chaining): If you are connecting multiple relay units in a daisy-chain series, use the data cables provided with the relay units
to connect the first unit’s RJ-45 OUT port to the next unit’s RJ-45 IN port.
3. After installing system hardware, complete the following configuration steps:
a. Add the REL driver and the relay interface unit to the VMX300(-E) server configuration. Each unit in a daisy-chain configuration must
be added to the VMX300(-E), and then configured with the appropriate settings. Note that the recommended baud rate for
communication between VMX300(-E) and the CM9760-REL is 19200. You must set this baud rate on the Communications tab when
you configure the CM9760-REL device in the VMX300(-E). (Refer to the VMX300(-E) Server Configuration Manual for instructions.)
b. Change the CM9760-REL settings to the following recommended settings for VMX300(-E) communication: RS-422, 19200 baud, no
parity, 8 data bits, 1 stop bit. (Refer to the CM9760-REL Installation/Operation manual for instructions.)
VMX300(-E)
RS-232
RS-422 REVERSED CABLE
WALL
BLOCK
TD(A
)
TD(B)
RD(A)
RD(B)
GND
+12VDC
TD(A)
TD(B)
RD(A)
RD(B)
1
2
3
4
7
6
5
8
RS-232 TO
RS-422
ADAPTER
CM9760-REL