Filter
Top Products
Command Line Interface 95
Line Commands
Set Termtype
Description Sets the terminal type for the current terminal session. term1, term2, and term3 refer to
the user-uploadable custom terminal definitions. If these are not present, the default is
wyse60.
User Level Restricted, Normal, Admin
Syntax
Option wyse60|vt100|ansi|dumb|tvi925|ibm3151te|vt320|hp700|term1|term2|term3
Show Line
Description Shows the line settings/information.
User Level Admin
Syntax
Line Service Commands
Set Telnet-Client
udp
Sets the line to listen for and/or send UDP data.
vmodem
The Device Server port behaves as if it were a modem to the attached device.
set termtype
[wyse60|vt100|ansi|dumb|tvi925|ibm3151te|vt320|hp700|term1|term2
|term3]
Specifies the type of terminal connected to the line:
z Dumb
z WYSE60
z VT100
z ANSI
z TVI925
z IBM3151TE
z VT320 (specifically supporting VT320-7)
z HP700 (specifically supporting HP700/44)
z Term1, Term2, Term3 (user defined terminals)
show line
Description Configures telnet parameters.
User Level Normal, Admin
Syntax
set telnet-client [termtype <terminal_name>] [line-mode on|off]
[map-cr-crlf on|off] [local-echo on|off] [echo <00-7f>]
[eof <00-7f>] [erase <00-7f>] [intr <00-7f>] [quit <00-7f>]
[escape <00-7f]
Options termtype
Type of terminal attached to this line; for example, ANSI or WYSE60.
line-mode
When On, keyboard input is not sent to the remote host until Enter is pressed,
otherwise input is sent every time a key is pressed. Default is
Off.
map-cr-crlf
Maps carriage returns (CR) to carriage return line feed (CRLF). The default value is
Off.