Filter
Top Products
Set IOChannel
146 IOLAN SDS/SCS/STS CLI Reference Guide, Version 3.6
Set IOChannel Analog (Temperature)
trigger-level
Specify the value that will trigger an alarm, the measurement is based on the Type and
Range that you specify. This value must not fall within the scope of the value used to
clear an alarm.
clear-mode
Specifies whether an activated alarm must be Manually cleared, or can be cleared when
the input drops below the specified value (when
Trigger Type is High) or goes above
the specified value (when
Trigger Type is Low).
clear-level
Specify that value that will clear an alarm, the measurement is based on the Type and
Range that you specify. This value must not fall within the scope of the value used to
trigger an alarm.
email
Sends an email alert to an email account(s) set up in the Server settings (the Line Email
Alert settings are not used with this feature) when an alarm is triggered or cleared. The
email alert data includes the severity level and the value that caused the alarm to trigger
or clear. The Email Alert is associated with
Level Critical.
snmp
Sends an SNMP trap when an alarm is triggered or cleared. The trap consists of the
severity level and whether the alarm was triggered or cleared.
syslog
Sends a message to syslog when an alarm is triggered or cleared. The syslog entry
includes the severity level and the value that caused the alarm to trigger or clear. The
syslog message is associated with
Level Critical.
Description Sets the Analog input channel settings for Temperature models.
User Level Admin
Syntax
set iochannel <analog_channel> type rtd|thermocouple
range <range_specifier>
set iochannel <analog_channel> alarm
[level 1|2|3|4|5 [mode on|off] [trigger-type disabled|low|high]
[trigger-level <decimal_value>] [clear-mode auto|manual]
[clear-level <decimal_value>] [email on|off] [snmp on|off]
[syslog on|off]]
Options analog_channel
Specify the Analog channel number, for example, a2 or a4 (this also applies to
Temperature models).
type
Specify the type of sensor you are using to measure temperature, either RTD or
thermocouple. The default is RTD.