Filter
Top Products
Configuring Users
62 IOLAN SDS/SCS/STS CLI Reference Guide, Version 3.6
Set User
sess-timer
The amount of time, in seconds, that the Session Timer will run. Use this timer to
forcibly close a user’s session (connection). When the
Session Timer expires, the
IOLAN will end the connection. The default value is
0 (zero), meaning that the session
timer will not expire (the session is open permanently, or until the user logs out). The
maximum value is 4294967
seconds. The User Session Timer will override the Line
Session Timer
, with the exception of reverse SSH or reverse Telnet sessions.
port
.For outbound User Services such as Telnet, SSH, TCP clear or SSL raw, this is the
target port number. The default value will change based on the type of
Service selected;
the most common known port numbers are used as the default values.
access-clustered-ports
When enabled, allows the user access to IOLANs that have been configured in the
clustering group. The default is on.
Description Sets users settings. Normal-level users can configure only their own settings.
Admin-level users can configure any users settings, including their own (with the
exception of their User Level, which must stay at Admin).
User Level Normal, Admin
Syntax
set user . [hotkey-prefix <00-7f>] [language english|customlang]
[password] [routing none|send|listen|send-and-listen]
Admin User
Only
set user .|<username>|* [callback on|off]
[framed-compression on|off] [framed-ip <IPv4_address>]
[framed-interface-id <IPv6_interface_id>]
[framed-mtu <64-1500>] [hotkey-prefix <00-7f>]
[idle-timer <0-4294967>]
[host-ip None|<IP_address>|<config_host>]
[language english|customlang]
[level admin|normal|restricted|menu] [password]
[line-access readin|readout|readwrite [on|off]|<line(s)> [0]]
[netmask <IPv4_address>] [phone-number <phone_number>]
[routing none|send|listen|send-and-listen]
[service dsprompt|telnet|tcp-clear|rlogin|ppp|slip|ssh|ssl-raw]
[sess-timer <0-4294967>] [port tcp-clear|telnet|ssh|ssl-raw
<TCP_port>] [access-clustered-ports on|off]
Options callback
When On, enter a phone number for the IOLAN to call the user back (the Callback
parameter is unrelated to the
Line Dial parameter).
Note: the IOLAN will allow callback only when a user is authenticated. If the protocol
over the link does not provide authentication, there will be no callback. Therefore, when
the
Line Service is set to PPP, you must use either PAP or CHAP, because these
protocols provide authentication. The default is
Off.
The IOLAN supports another type of callback,
Roaming Callback, which is
configurable when the
Line Service is set to PPP.