Filter
Top Products
Getting started
7
3.4.2 via the PBC method
Check that your Wireless router and that the other WPS device are
connected and ON
Push and hold the WPS button, located on the front side on your
router, for 3 seconds
Push and hold the WPS button of the other WPS device for
3 seconds (refer to the manual of the other WPS device for
location)
• The other WPS device is installed on your network
OR
Check that your Wireless router and that the other WPS device are
connected and ON
On your Internet Browser, enter http://192.168.2.1 in the address
field and click on GO to access the webpages
Click on the WIRELESS tab on the left side of the page and select
PBC to open the corresponding subpage
Click on START PBC
• The other WPS device is installed on your network
Note
The push and hold procedure on the two WPS buttons (router and
other WPS device) has to be done within a two minutes’ interval.
3.4.3 via the Manual configuration
This method enables you to configure client devices without WPS
function.
On your Internet Browser, enter http://192.168.2.1 in the address
field and click on GO to access the webpages
Click on the WIRELESS tab on the left side of the page and select
Manual to open the corresponding subpage
Take note of the settings displayed and configure your non-WPS
device accordingly
• Your non-WPS device is installed on your network
1
2
3
1
2
3
4
1
2
3