Filter
Top Products
8 Philips · PPX1430
3 Initial Operation
Connect power supply /
charge battery
1 Insert the small plug of the power supply into the
socket on the rear side of your device.
2 Plug the power supply into the mains.
3 During the charging process, the indicator light on
the top of the device will be red. When the battery
is fully charged, it will turn green.
4 Charge the built-in battery before using for the first
time for at least 3 hours. This will prolong, the life of
the battery.
Initial Installation
1 Switch the device on using the on/off switch on the
side.
2 Turn the device towards an appropriate projection
surface or wall at a distance of at least 0,2m and at
most 3m. Make sure the projector is in a secure
position.
3 Use the focus wheel on the top to adjust the image
sharpness.
4 Select the desired menu language using /.
5 Confirm with à.
Installing or Changing the
Batteries of the Remote
Control
Risk of explosion with incorrect type of batteries
1 To access the battery, disengage the locking mecha-
nism () and slide out the battery compartment
().
2 Insert the new batteries into the battery compart-
ment with the positive and negative poles as shown
on the back of the remote control. Make sure the
polarities(+ and -) are aligned correctly.
CAUTION!
Mains Voltage at the Site of Installation!
Check whether the mains voltage of the
power supply matches the mains voltage avail-
able at the setup location.
Notice
The main menu appears instead of
the language selection
The device has already been installed. In
order to change the menu language, pro-
ceed as follows:
1 Select with the navigation keys Settings.
2 Confirm with à.
3 Select using / Language.
4 Confirm using à.
5 Select the desired language with /.
6 Confirm with à.
7 You can exit with ¿.
DANGER!
Risk of explosion with incorrect type of
batteries
Use only batterytype:CR 2025.
CAUTION! RISK OF EXPLOSION IF BAT-
TERY IS REPLACED BY ONE OF AN
INCORRECT TYPE.