Filter
Top Products
R11 Series Drive Command Reference Manual Version 1.00
4.12.2 Mode Pages
The drive is not supported the Parameters Savable (PS) bit and must be set to zero.
The Page Code field identifies the format and parameters defined for that mode page.
The drive supports following Mode pages.
Table 25 - Mode Page Codes
Page code Description Section
01h Error Recovery Page 4.12.2.2 on page 42
05h Write Parameters Page 4.12.2.5 on page 43
08h Caching Page 4.12.2.1 on page 42
0Eh CD Audio Control Page
1Ah Power Condition Page 4.12.2.3 on page 42
1Dh Time-out & Protect Page 4.12.2.4 on page 42
2Ah Capabilities & Mechanical Status Page 4.12.2.6 on page 44
3Fh Return all pages (valid only for the MODE SENSE
command)
4.12.2.1 Caching Page
The Caching Page is supported for compatibility of other CD-R/RW drive. This page has no effect on
write/read operation. The returned Caching parameters by the MODE SENSE (10) Command are modified
to the new parameters after receiving new parameters by MODE SENSE (10) Command.
Table 26 - Caching Parameter
Bit
Byte
7 6 5 4 3 2 1 0
0 PS Reserved Page Code = 08h
1 Page Length = 0Ah
2 IC ABPF CAP DISC SIZE WCE MF RCD
3 Demand Read Priority Write Retention Priority
4 (MSB)
5
Disable Pre-fetch Transfer Length
(LSB)
6 (MSB)
7
Minimum Pre-fetch
(LSB)
8 (MSB)
9
Maximum Pre-fetch
(LSB)
10 (MSB)
11
Maximum Pre-fetch Ceiling
(LSB)
Default value of the WCE bit is one. Default value of any other bits and field is zero.
4.12.2.2 Error Recovery Parameters Page
The AWRE and ARRE bits are not supported and are ignored.
The TB, RC, DTE and DCR bits are ignored.
The Write Retry Count field is reserved.
The PER bit and EMCDR field are used to control the defect reporting.
4.12.2.3 Power Condition Page
The default value of an Idle bit is one. The default value of the Idle Timer field is 00000258h (1 minute).
The default value of the Standby bit is one. The default value of Standby Timer field is 000012C0h (8
minutes).
4.12.2.4 Time-out & Protect Page
The DISP, SWPP bits are not supported and must be set to 0.
Page 42