Filter
Top Products
DM500™ and DM550™ Series Digital Mailing System Operating Guide
SV61436 Rev. D 9 - 11
c. If the tank is still not
filled to the correct
level, remove the moist-
ener tank and drain it
over the
front of the
machine, then replace
the tank and check the
level again after 5 min-
utes.
14. Once you verify that the
moistener t
ank is filled to
the correct level with E-Z
Seal® Solution, gently push
the tank all the way back to
its original position.
Replace the moist-
ener brush assembly
by pu
shing it back on
its track until it snaps
into position.
Check to make sure
tha
t the flap blade of
the moistener brush
assembly is under
(and not over) the
stripper finger as
shown here.
15. Verify that the moist-
ener brush assembly
is perfe
ctly level with
the feed deck.
16. Close the feed cover.
17.
Printer
Maintenance
The printer components, consisting of the printer nozzle, ink cartridge and
printhead, require minimum maintenance to ensure clean, clear meter
imprints on your mail.
If the print quality deteriorates and you cannot improve it with the proce-
dures in this chapter, contact the Pitney Bowes Help Desk. Refer to the
Pitney Bowes Contact Information List at th
e front of this guide for the
phone number.
Stripper
finger
Flap
Blade
Feed
deck
Moistener Brush
Assembly