Filter
Top Products
Chapter Four: System Setup
Attach the keyboard and all peripherals before you power up the unit. All connections are made
at the bottom of the unit. If you have not yet attached the Clean Screen PC to a standard mount-
ing bracket, then lay the unit face down before you attach the keyboard and peripherals. Be sure
to use a non-abrasive cloth or other material to protect the face plate.
Figure 15
Connecting the Keyboard
Your Clean Screen can use any AT style keyboard.
Connecting Peripherals
Mouse
The Clean Screen PC uses a serial type mouse. COM A is the default.
Printer
The parallel port can be used for connecting a local printer.
PCMCIA Port
The Clean Screen allows the connection of one Type III PCMCIA Expansion Card or the use of
two Type I or Type II PCMCIA Expansion Cards.
Floppy Drive Connector
Please note that this is NOT a standard floppy drive connection. The Clean Screen is not
designed for regular use with an external floppy drive. The connector will only allow use of a
Planar 3.5" external floppy drive and is intended only for diagnostic and service use. If you need
to load drivers for your operating system or other programs, you will need to obtain the correct
drive. See What if I’m missing something? in the Before You Begin section.
Chapter Four: System Setup 13
Parallel Headphone/ ISA 16-bit
Power Interface Power Com A Speaker Output Jack Expansion Slot
Switch or Printer Port Connection Port (32 to 300 Ohms) (
1
⁄2 card size)
AT Keyboard Com B Floppy Drive Connector Line In PCMCIA Type III Microphone
Connection Port (custom interface Jack Expansion Port Jack
for diagnostic or
service use only)
CS Manual LAYOUT#1787 3/9/98 5:33 PM Page 13