Filter
Top Products
Introduction
3
Physical Details
Front Panel
The front panel of ADE-3000 has 2 LEDs for one LAN port and one ADSL port. Figure
2 displays a front panel of the router.
Figure 1-2: Front Panel
LED definitions
Rear Panel
Figure 1-3: Rear Panel
Button definition
Reset Button This button has two (2) functions:
· When pressed and released, ADE-3000 will reboot
(restart).
· When reset button is pressed over 5 seconds and
then release. ALL data will be clear and restore ALL
settings to the factory default values.
Restore Default IP Address and Clear Password
If ADE-3000's IP Address or password is lost, the following procedure can be used to
recover from this situation.
Pressing the Reset button for more than 5 seconds. ADE-3000 will restore to factory
default setting. Note that this should be done only when you had tried all the
troubleshooting options. Pressing the Reset button during operation may bring you into
the risk of creating IP address conflict between your PC and the router. In such a case,
you may be compelled to reboot your entire system(s).
Status ADSL On – ADSL LED status will be on after chaining procedure
with DSLAM is completed
Status LAN On –LAN LED will be on while RJ-45 connector is plugged
in.
PDF created with FinePrint pdfFactory Pro trial version http://www.fineprint.com