Filter
Top Products
ADE-4000 User Manual
14
PPPoE, PPPoA Connection for WAN (Routing mode)
If PPPoE (Point-to-Point Over Ethernet) or PPPoA (Point-to Point Over ATM) is
provided to establish communications, User Name and Password are required to
be obtained from ISP. And VCI/VPI values must be obtained from them as well, for
some local ISPs don’t offer this information actively.
To set up a PPPoE or PPPoA connection for WAN, follow the instructions below:
Step 1
Fill in the VCI/VPI entries with the information you get from ISP.
Step 2
Choose suitable packet encapsulation (PPPoA LLC/VC-Mux, PPPoE LLC/VC-Mux).
Disable “Bridge”. (Packet encapsulation information also has to be obtained from
ISP.)
Figure 4-7: Encapsulation types of PPPoE/PPPoA
Service Name
If your ISP provides this info, please type it into the field or leave it blank (factory
default).
User Name and Password
Fill in the entries with the
information provided by ISP.
Disconnect Timeout
It is the amount of time you would like to pass before the Router drops your Internet
connection due to inactivity. Enter zero (0) in the field to remain Internet connection
on at all time. The idle time ranges from 0 to 32767 seconds.
Authentication
When AUTO option is chosen, the PAP mode will run first then CHAP.
Automatic Reconnect
If you check this option, the Disconnect Timeout should set to 0 second. Otherwise
there will be a conflict between them.
DHCP
Leave this option unchecked.