Filter
Top Products
ADSL Wireless Firewall Router User Guide
68
Routing
Overview
• If you don't have other Routers or Gateways on your LAN, you can ignore the
"Routing" page completely.
• If the ADSL Wireless Firewall Router is only acting as a Gateway for the local LAN
segment, ignore the "Routing" page even if your LAN has other Routers.
• If your LAN has a standard Router (e.g. Cisco) on your LAN, and the ADSL Wire-
less Firewall Router is to act as a Gateway for all LAN segments, enable RIP
(Routing Information Protocol) and ignore the Static Routing table.
• If your LAN has other Gateways and Routers, and you wish to control which LAN
segments use each Gateway, do NOT enable RIP (Routing Information Protocol).
Configure the Static Routing table instead. (You also need to configure the other
Routers.)
• If using Windows 2000 Data center Server as a software Router, enable RIP on
the ADSL Wireless Firewall Router, and ensure the following Windows 2000 set-
tings are correct:
• Open Routing and Remote Access
• In the console tree, select Routing and Remote Access , [server name], IP
Routing, RIP
• In the "Details" pane, right-click the interface you want to configure for RIP
version 2, and then click "Properties".
• On the "General" tab, set Outgoing packet protocol to "RIP version 2 broad-
cast", and Incoming packet protocol to "RIP version 1 and 2".
Routing Screen
The routing table is accessed by the Routing link on the Administration menu.
Using this Screen
Generally, you will use either RIP (Routing Information Protocol) OR the Static Routing
Table, as explained above, although is it possible to use both methods simultaneously.
Static Routing Table
• If RIP is not used, an entry in the routing table is required for each LAN segment
on your Network, other than the segment to which this device is attached.
• The other Routers must also be configured. See Configuring Other Routers on
your LAN later in this chapter for further details and an example.