Filter
Top Products
User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
565
GVRP configuration: Enabled
Console#
garp timer
This command sets the values for the join, leave and leaveall timers. Use the no form to restore the timers’ default values.
Syntax
garp timer {join | leave | leaveall} timer_value
no garp timer {join | leave | leaveall}
{join | leave | leaveall} - Which timer to set.
timer_value - Value of timer.
Ranges:
join: 20-1000 centiseconds
leave: 60-3000 centiseconds
leaveall: 500-18000 centiseconds
Default Setting
join: 20 centiseconds
leave: 60 centiseconds
leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Group Address Registration Protocol is used by GVRP and GMRP to register or deregister client attributes for client
services within a bridged LAN. The default values for the GARP timers are independent of the media access method or
data rate. These values should not be changed unless you are experiencing difficulties with GMRP or GVRP
registration/deregistration.
Timer values are applied to GVRP for all the ports on all VLANs.
Timer values must meet the following restrictions:
-leave >= (2 x join)
-leaveall > leave
Set GVRP timers on all Layer 2 devices connected in the same network to the same values.
Otherwise, GVRP may not operate successfully.