Filter
Top Products
User’s Manual of WGSW-24040 / WGSW-24040R
SGSW-24040 / SGSW-24040R
24
SGSW-24040 Rear Panel
Figure 2-7 Rear panel of SGSW-24040
SGSW-24040R Rear Panel
Figure 2-8 Rear panel of SGSW-24040R
■ AC Power Receptacle
For compatibility with electric service in most areas of the world, the Managed Switch’s power supply automatically adjusts
to line power in the range 100-240VAC and 50/60 Hz.
Plug the female end of the power cord firmly into the receptalbe on the rear panel of the Managed Switch. Plug the other
end of the power cord into an electric service outlet then the power will be ready.
Power Notice:
The device is a power-required device, it means, it will not work till it is powered. If your networks should
active all the time, please consider using UPS (Uninterrupted Power Supply) for your device. It will
prevent you from network data loss or network downtime.
In some area, installing a surge suppression device may also help to protect your Managed Switch from
being damaged by unregulated surge or current to the Switch or the power adapter.
■ Stack ports
SGSW-24040 / SGSW-24040R
There are two High-Performance stack ports on the rear panel. One is STX1 / Cascade Down and the other is STX2 /
Cascade UP.
• When stacked, the STX1 / Cascade Down port should connect to the other switch’s STX2 / Cascade UP port and the
STX2 / Cascade UP port should connect to other switch’s STX1 / Cascade Down out.
• You can just use attached PLANET CB-STX50 or longer stack cable CB-STX200 connector to stack.
• The CB-STX50 and CB-STX200 are Cross-Overed HDMI cables, only attached PLANET stack cable can be used.
• Plug-and-play connection.