Filter
Top Products
WGS3 Layer 3 Switch User’s Manual
- 197 -
5.7.5.1 Subnet Configuration). Static routes take precedence over dynamically learned routes and
remain in the table until you remove them or the corresponding IP interface from this switch.
Parameter Description
Destination
Network
A destination network, subnet or host.
Destination
Mask
The subnet mask that specifies the bits to match. A routing entry will be used for a packet
if the bits in the address set by the destination mask match the Destination Network
VLAN The VLAN within which the gateway or destination address resides.
Next Hop The IP address of the router at the next hop.
Note that the network portion of the next hop must match that used for one of the subnet
IP interfaces configured on this switch. (See “
5.7.5.1 Subnet Configuration”.)
Type The IP route type for the destination network. This switch supports the following types:
Direct - A directly connected subnetwork.
Indirect - A remote IP subnetwork or host address.
Routing
Metric*
A relative measure of the path cost from this switch to the destination network.
* This value depends on the specific routing protocol.