Filter
Top Products
29
WAN Interface Settings To configure WAN Interface IP
Dynamic IP The ISP requires you to obtain an IP address by DHCP before
connecting to the PPTP server.
MAC Cloning
Select <Enabled> to allow replacing the WAN MAC address
with a specific MAC address.
MAC Address
Your ISP may require a particular MAC address in order for
you to connect to the Internet. This MAC address is the PC’s
MAC address that your ISP had originally connected your
Internet connection to. Type in this MAC address in this
section or use the “Clone MAC Address” button to replace
the WAN MAC address with the MAC address of that PC.
Static IP
The ISP gives you a static IP to be used to connect to the
PPTP server. You must type in the related IP address such as
IP Address, Subnet Mask and Gateway.
PPTP Settings
PPTP Account Enter the PPTP Account provided by your ISP for the PPTP
connection.
PPTP Password Enter the Password provided by your ISP for the PPTP
connection.
Retype Password Re-enter the Password for confirmation.
PPTP Gateway If your LAN has a PPTP gateway, then enter that PPTP
gateway IP address or domain name here. If you do not have
a PPTP gateway then enter the ISP’s Gateway IP address
above or domain name.
Connection ID This is the ID given by ISP. This is optional.
Maximum Idle Time You can specify an idle time threshold (seconds) for the WAN
port. This means if no packets have been sent (no one using
the Internet) during this specified period, the router will
automatically disconnect the connection with your ISP.
Connection Mode Select the desired option:
Keep-alive (maintain connection)
The connection will never be disconnected by this device. If
disconnected by your ISP, the connection will be re-
established immediately. (However, this does not ensure that
your Internet IP address will remain unchanged.)
Auto-Connect
An Internet connection is automatically made when required,
and disconnected when idle for the time period specified by
the "Maximum Idle Time (60~3600)".
Manual-on