Filter
Top Products
E-25
Power Cable Connections and Switching the Power On/Off
Finishing
1
Switch off the power of the connected equipment
2
Switch off the power of the projector
Main unit operation: Press and hold the POWER button for a while.
Remote control operation: Press the POWER OFF button.
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen will go
off (in about 5 seconds) and the projector will enter the power-off op-
eration.
Note
* The operation can be cancelled by pressing a button other than the POWER
button.
* One more press of the POWER (POWER OFF) button will switch off the
power.
Flashes amber
(Approximately 120 seconds)
Lit amber
Standby mode
The POWER indicator changes to flashing amber and
lights a steady amber after about 120 seconds (when
the unit enters the standby mode).
3
Unplug the power cable
Check that the POWER indicator is lit in amber and then unplug the power cable.
The POWER indicator will go off when the power cable is unplugged.
Warrning
Do not unplug the power cable while the POWER indicator is flashing amber. Doing so may shorten the life of the lamp or
damage the projector.
ON OFF
POWER
Power Off
OK
?
Power Off
OK
?
POWER
STATUS
POWER
STATUS
POWER
STATUS
Lit green