Filter
Top Products
2. Wipe the Feed Roller from side to side and then roll it.
3. Clean the glass side to side. Repeat this until its entire surface is cleaned.
Attention
Do not spray cleaner directly onto the scanner glass. Excess liquid
residue may fog or damage the scanner.
4. Wait for cleaned areas to dry completely.
5. Press down the revolt bracket until it snaps back into place.
C
C
a
a
l
l
i
i
b
b
r
r
a
a
t
t
i
i
n
n
g
g
t
t
h
h
e
e
S
S
c
c
a
a
n
n
n
n
e
e
r
r
Calibrate the scanner if colors appear in areas that should be white, or colors of
the scanned image and the original vary a lot. This allows you to adjust and
compensate for variations that can occur in the optical component over time by its
nature.
The following describes how to calibrate the scanner:
1. Insert the special calibration sheet face up into the page feed slot of the
scanner.
24