Filter
Top Products
Place the scanner at the end of the chain and use the termina-
tor provided. Do not add any additional terminators. If one
external device has an internal terminator, see the previous
example. Use only approved SCSI cables.
Tu r ning on the scanner
1 With the scanner off, plug the power cord provided into the
scanner (picture 4), and then into an appropriate grounded
outlet. The scanner can operate over a voltage range from 100
to 240 VAC.
2 Turn on the scanner; the switch is next to the power
connector. The POWER indicator light on the front of the unit
will light, the cold cathode lamp will come on (visible
through the slit on the top of the unit), and the READY indica-
tor will flash briefly. The scanner will perform a self-test that
lasts for a few seconds. If no problems are detected, the
READY light will stay lit. The cold cathode lamp will also
stay on.
3 Once the ready light is lit, turn on your computer.
Setup and use 2-9
Scanner and another
unterminated device
4