Filter
Top Products
KIRK Wireless Server 1500 Installation and Maintenance
5.4 Installing a KIRK Expansion Board 1500
If the KWS1500 installation requires more than eight Base Stations, then a KIRK
Expansion Board 1500 will be required. Installing a KIRK Expansion Board 1500 within
the KWS1500 will increase its capacity to the maximum of 16 Base Stations. Follow these
steps to install the KIRK Expansion Board 1500 within the KWS1500.
KIRK Wireless Server 1500 Interior View
Do not remove the top cover while the unit is connected to a power source.
Failure to disconnect the unit from the power source while the top cover is
removed can cause severe electric shock, damage to electrical components,
and even death.
1. Disconnect the KWS1500 from AC power.
2. Remove the top cover of the KWS1500 by removing the eight screws securing the
cover. There are two screws on each side of the unit and four on the rear.
3. Locate the KIRK Expansion Board 1500 connector and plastic stand-off pin positions
on the motherboard.
4. Insert the two included plastic stand-off pins to the motherboard. Make sure they
click into place and are secure.
5. Connect the KIRK Expansion Board 1500 to its connector, making sure the card is
connected securely to the connector on the left side of the motherboard. Apply
72160400_issue_B 34