Filter
Top Products
11
Powerware
®
5115 User’s Guide : www.powerware.com
CHAPTER 3
OPERATION
This section describes:
:
Turning the UPS on and off
:
Starting the UPS on battery
:
Standby mode
:
The UPS front panel and LEDs
:
Initiating the self-test
Turning the UPS On
To turn on the UPS, press the button on the front panel (shown in
Figure 11). After the UPS is turned on, it conducts a self-test and enters
Normal mode. The
indicator illuminates indicating that power is
available from the UPS output receptacles.
Starting the UPS on Battery
To turn on the UPS without using utility power, press and hold the
button for two seconds. When the UPS starts on battery, it does not
conductaself-testtoconservebatterypower.
NOTE The UPS does not auto-detect the input frequency when starting on battery; the
default is the last frequency used by the UPS.
Turning the UPS Off
To turn off the UPS, press the button on the front panel and then
unplug the UPS from the power outlet. If you do not unplug the UPS, it
remains in Standby mode.