Filter
Top Products
Installation
4
Powerware
®
5115 User’s Guide : www.powerware.com
WARNING
:
This UPS contains its own energy source (batteries). The output receptacles may
carry live voltage even when the UPS is not connected to an AC supply.
:
Do not remove or unplug the input cord when the UPS is turned on. This removes
the safety ground from the UPS and the equipment connected to the UPS.
:
To reduce the risk of fire or electric shock, install this UPS in a temperature and
humidity controlled, indoor environment, free of conductive contaminants. Ambient
temperature must not exceed 40
°C (104°F). Do not operate near water or excessive
humidity (95% max).
:
To comply with international standards, the sum of earth leakage current from the
load connected to the UPS must not exceed 1.5 mA.
Installing the UPS
The following steps explain how to install the UPS. Figure 2 shows a
typical installation only. See “UPS Rear Panels” on page 6 for the rear
panel of each model.
1. If you are installing power management software, connect your
computer to the UPS communication port using the supplied
communication cable.
NOTE If you need to change the factory-set defaults for the output voltage or input
voltage range, see “Voltage Configuration” on page 13 before installing the UPS.
2. On 230V models, plug the power cord into the input connector
on the UPS rear panel.
Customer-supplied power cords must be correctly rated for the
UPS (see “Specifications” on page 23). You can also use the
powercordfromthelargestloadifitiscorrectlyrated.