Filter
Top Products
11
Powerware
®
5119 User’s Guide www.powerware.com
CHAPTER 3
OPERATION
This section describes:
Turning the UPS on and off
Starting the UPS on battery
Standby mode
The UPS front panel and LEDs
Initiating the self-test
Turning the UPS On
After the UPS is connected to a power source, it conducts a self-test and
enters Standby mode. To turn on the UPS, press the On
buttononthe
front panel (shown in Figure 10). The Power On indicator illuminates
indicating that power is available from the rear receptacles.
Starting the UPS on Battery
To turn on the UPS without using utility power, press and hold the
On button for three seconds. When the UPS starts on battery, it does
not conduct a self-test to conserve battery power.
Turning the UPS Off
To turn off the UPS, press the Off