Filter
Top Products
EST150
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 5
1) Measure distance from center of lens to the top of the mount carriage (C).
2) Add the distance from the ground to the top of the screen (A). Add the projector manufacturers recommended
offset from the projector manual (B). Add the measurement from Step 1 (C), and then add the mounting screw
offset (D) to the total.
(Example: A + B + C + D = ?)
3) Add the measurements to determine the mounting height mark. Place a mark at the top of the total calculated
height measurement starting from the ground up. This height mark will determine your mounting points.
Refer to the projectors User’s Manual to determine the offset of the projector lens to the top of the
screen/whiteboard (B).
Lens
Mount Carriage
Projector
In order to determine the installation height and throw distance, the mount carriage must be mounted
to the projector.
Top of Screen
Mark
Legend
A - Distance from ground to the top of the
screen/whiteboard (viewable area).
B - Manufacturers recommended offset
measurement. This measurement will
be listed in the Users Manual.
C - Center of the lens to the top of the
projector bracket.
D - If single-stud EST150, add 5.14˝ to
the calculated total.
This total distance will be the location for the
lower mounting point.
Proceed to the “Wood Stud Installation”
section.
Ground
Determining the Installation Height
D