Filter
Top Products
4. The Recorder Tray then automatically shuts. Robotic Disc
Transporter will automatically check the Input Bin to make
certain that only one disc was picked.
Through software control, you can perform a test on each
disc before recording. If a disc does not pass (meaning that
all or part of that disc is not recordable), the Robotic Disc
Transporter picks it out of the CD Tray and sends it to the
Reject Area.
5. The Recorder is now writing to the disc. If you were to
fully record a CD with data, audio, video or music
(650 MB), recording time is about 3 ½ minutes each.
A full DVD records in about 30 minutes. Most jobs don't
fill the entire disc, so recording time is usually less than
this. After recording, the Recorder Tray opens
automatically. The Robotic Disc Transporter will lift the
disc out of the Recorder Tray. The Recorder Tray will
close, and the Printer Tray will open. The Robotic Disc
Transporter will lower the disc into the Printer Tray, and
the Printer Tray will then automatically close.
6. If publishing more than one disc, the Robotic Disc
Transporter will load the Recording Drive with a blank
disc from the Input Bin to start recording the next round.
7. Once recording has started, the Publisher will be start
printing directly onto the surface of the recorded disc. This
simultaneous recording and printing of discs greatly
increases the throughput of your Publisher.
6 Getting Started
510877.qxd 1/9/2004 11:57 AM Page 6
TOC
INDEX