Filter
Top Products
42 Printing Using a Macintosh
Tear Off Position
If Output Mode (described later in this section) is set to
Present, the printer will present your labels over the Tear Bar
for easy removal. This tear off position is set at the factory.
If fine tuning is needed to align the break in your label stock
over the Tear Bar, increase this setting to eject the label further;
decrease this setting to eject the label stock less. The unit of
measure is 0.1 mm.
Cut Position
If a label cutter attachment is connected to the printer you can
fine tune the cut position between the labels. Increase this
value to move the label further out before the cut; decrease
this value to eject the label stock less before the cut.
Left Margin Offset
This will be factory calibrated. If fine tuning is needed, increase
this setting to move the image right on the label; decrease this
setting to move the image to the left on the label. The unit of
measure is 0.1mm.
Top of Form (TOF)
This setting allows you to fine tune the print starting position
on your label stock. This will be factory calibrated. If fine
tuning is needed, increase this value to move the image down
on the label. Decrease this value to move the image up the
label. The unit of measure is 0.1mm.
Click the Test Offsets button
to send a test print to the
printer that will help you
adjust the TOF and Left
Margin Offset. The printer
will print the pattern shown.
Adjust the values so that both
black bars print on the label
with no white space on the
label and no ink on the liner.
+
+
-
-
LEFT OFFSET
TOF
(10 units)
1.0 mm
510984.qxd 11/21/2006 9:09 AM Page 42
TOC
INDEX