Filter
Top Products
Printing Using a Macintosh 43
Sensor Type
Sensor Type refers to the method the printer will use to detect
the print starting position for each label. If you are using
standard die-cut labels or Through-hole label material where
a hole is punched through each label for alignment purposes
use the Through-hole/Die-Cut setting. Use Reflective for
black stripe sensing label material where a pre-printed line on
the back of the label stock indicates the break between labels.
If you have continuous stock with no die-cut, reflective mark
or holes set the sensor type to Continuous Feed. This will
turn off the stock sensor.
Output Mode
Do not present (use with Rewinder). The label stock does not
move after the last label is printed. This means that part of the
last label printed is still in the printer. This should be used
only if you have a label rewinder attached.
Present (Default). This setting will cause the printer to feed the
last label printed forward so that it and the previously printed
labels can be torn off using the tear bar. This will occur only if
there are no other print jobs in queue.
Cut (using optional cutter). Use this setting only if you have
the label cutter attachment (Primera Part # 074263)
510984.qxd 11/21/2006 9:09 AM Page 43
TOC
INDEX