Filter
Top Products
28 PI-SCX System Manual Version 2.E
28
Super VGA monitor and graphics card supporting at least 256 colors with at least
1 Mbyte of memory. Memory requirement is dependent on desired display
resolution.
Two-button Microsoft
®
-compatible serial mouse or Logitech
®
three-button
serial/bus mouse.
USB 2.0 Protocol:
AT-compatible computer with Pentium 3 or better processor and runs at 1 GHz or
better.
Windows
®
XP (32-bit, SP3 or later) or Vista
®
(32-bit).
Native USB 2.0 support on the mother board or USB Interface Card (Orange
Micro 70USB90011 USB2.0 PCI is recommended for desktop; SIIG, Inc. USB
2.0 PC Card, Model US2246 for laptop)
Minimum of 256 Mbytes of RAM.
CD-ROM drive.
Hard disk with a minimum of 80 Mbytes available. A complete installation of the
program files takes about 17 Mbytes and the remainder is required for data
storage, depending on the number and size of spectra collected. Disk level
compression programs are not recommended.
Super VGA monitor and graphics card supporting at least 256 colors with at least
1 Mbyte of memory. Memory requirement is dependent on desired display
resolution.
Two-button Microsoft compatible serial mouse or Logitech three-button
serial/bus mouse.
Verifying Controller Voltage Setting
The Power Input Module on the rear of the Controller
contains the voltage selector drum, fuses and the power cord
connector. The appropriate voltage setting is set at the
factory and can be seen on the power input module.
Each setting actually defines a range and the setting that is
closest to the actual line voltage should have been selected.
The fuse and power requirements are printed on the panel
above the power input module. The correct fuses for the
country where the ST-133 is to be shipped are installed at
the factory.
Note: On ST-133s, the voltage ranges and fuse ratings may
be printed above or below the power module (Figure 7).
Figure 7. Controller
Power Input Module