Filter
Top Products
D A I L Y O P E R A T I O N
26
3. Continue to press the FORM SELECT button until the desired form
name is shown on the top line of the display. The form name will
be FORM 0 through FORM 9 or the actual name of the form if the
name has been set in Setup. If the desired form is not considered to
be “loaded” by the printer, <Not Loaded> will flash on the bottom
line of the display. In the case of the FormsMaster 8003 the not
loaded message will alternate with the path(s) that this form is to be
loaded in.
Loading the Form in the Tractors
4. Open the paper door on the front of the printer. This will provide
access to the tractors as shown below. If your printer is a
FormsMaster 8000, only one set of tractors will be available and you
may skip ahead to step 6.
FormsMaster 8003 tractors
5. Depending upon which path(s) the new form is to be placed in, you
may need to tilt the front and/or center tractors forward as shown.