Filter
Top Products
2–20 Setting Up the Printer
Check for Interference
The printer should be used only with FCC, VDE, or CE certified computing
devices. If the printer is installed within 10 feet of audio or video equipment,
interference may occur. Determine if there is interference by turning the printer
ON and OFF and checking the audio and video equipment for noise spikes. If
interference occurs, perform the following:
1. Relocate the printer or the electronic device affected by the interference,
including the antenna, if applicable.
2. Ensure that the printer and electronic device are on separate power
circuits or install AC line filters.
3. Ensure that the wall outlets are properly grounded.
If these steps do not resolve the problem, refer to the Federal Communications
Commission Booklet, “How to Identify and Resolve Radio – TV Interference
Problems” (stock number: 004–000–00345–4), available through the U.S.
Government Printing Office, Washington, D.C. 20402.
Transporting the Printer
Take precautions to prevent damage to the printer during transport. If a move
requires trucking, use the original packaging materials.
Short Distance Transport
1. Turn off the printer and unplug the power cord from the wall outlet.
2. Remove the paper.
3. Remove all external communication and interconnection cables (AC line
cord, coax cable, any optional attachment cards, etc.) from the printer.
4. Before you remove the developer unit, place several sheets of paper in
front of the printer and on a work surface that you will set the developer
on. Do this in case any toner spills.
5. Remove the developer unit. (It is a good idea to have a toner vacuum
handy when performing this step.)
6. Place the developer unit in a sealable plastic bag.