Filter
Top Products
3–9Configuring the Printer
c. Press DOWN.
Load Config.
Factory*
d. Press NEXT or PREV to cycle through the options (0–8).
NOTE: Configuration “0” is the factory default configuration and cannot be
altered. “0” is not displayed. The display shows “Factory, 1–8.”
e. When the desired number is displayed, press ENTER to make
the selection. The following is displayed briefly:
Loading Saved
Configuration
The following is displayed to indicate the configuration has been
loaded:
Load Config.
(selected number) *
If the configuration you have selected for loading has not been
previously saved, the following error message is displayed briefly:
CONFIG. DOES NOT
EXIST/ Save First
2. Move through the menu and change all the desired values. (In this
example, you would change the interface type value from Serial to
Centronics.)
3. Press ENTER to save each new value. An asterisk is displayed next to
the selected value.
4. Before saving the modified configuration, you must delete the original.
a. Press ON LINE twice to take the printer offline.
OFFLINE
CONFIG. CONTROL