Filter
Top Products
3–6 Configuring the Printer
ENTER SWITCH
UNLOCKED
6. If there are more values you want to change, use the UP, DOWN, NEXT
and PREV switches to access the value and press ENTER to select it.
7. At any time, you may press UP to return to the options one level higher.
8. At any time, you may also press ON LINE to save your changes
temporarily, exit the configuration menu, and place the printer
online
.
9. Once you have finished selecting all of your options, you can save your
configuration for later access. Save the configuration as described on
page 3–12 if desired.
IMPORTANT
If you do not save your configuration, all of the new values are lost
when you turn off the printer. (Refer to “Config Control” on page 3–12.)
Saving a Configuration
You can save up to eight different configurations to meet unique print job
requirements.
For example:
Config. 0: Factory Default (This cannot be altered. See page 3–12 .)
Config. 1: Selects RS–232 Serial Interface
Selects Image Width of 4 inches
Selects Paper Length of 24 inches
Selects Image Shift of 1 inch, etc.
Config. 2: Selects Dataproducts Parallel Interface
Selects Image Width of 8 inches
Selects Paper Length of 11 inches
Selects Image Shift of 3/20 inch, etc.
The configurations are saved and stored in flash memory for later use. These
configurations, including the factory default, will not be affected when the printer
power is turned off. If you do not save your configuration before you turn off the
printer, the current configuration is lost.