Filter
Top Products
Chapter 2 QUICK SETUP Menu
40
QUICK SETUP Menu
QUICK SETUP
Validator Funct.
6
Print Intensity
6ips* 2-10 ips
1
Print Speed
Print Mode
Paper Feed Shift
Label Width
Label Length
Orientation
Transfer* Direct
4.1, 6.6, or 8.5 inches*
2, 4
Portrait* Landscape Inv. Portrait Inv. Landscape
-3* -15to15
00.1 to 8.5 inches
4
0.00 inches*
2
4 or 6 inches*
2, 4
00.1 to 99.0 inches
5
-0.50 to
X
inches
3
Run Calibrate
Auto Calibrate
1* 1-8
Factory* 1-8
Save Config.
Power-Up Config.
Ver Image Shift
Hor Image Shift
0.00 inches*
2
-1.00to1.00inches0.00 inches*
2
-1.00 to
X
inches
3
Enable* Disable
Tear-Off Strip* Tear-Off Peel-Off Cut
Media Handling
Continuous
Gap/Mark Sensor
Disable* Mark Gap Advanced NotchAdvanced Gap
Notes:
* = Default
1
Maximum value depends on the width of the
printer model and printhead.
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL)
See the
T5000e User’s Manual
for information.
3
Based on the current value setting for the Label
Length menu, up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the
printer model.
5
Maximum value depends onmodel width andsize
of DRAM installed.
6
Appears only if the validator option is installed.