Filter
Top Products
RFID CONTROL Submenus
53
RFID CONTROL Submenus
Reader
This menu item allows the user to enable or disable the RFID UHF
encoder. The default is Enable.
Tag Type
This menu item allows the user to specify the tag type in use. The
default is Class 1. Other classes may be added in the future.
Error Handling
This menu item allows the user to disable the printing of the
Overstrike pattern for a failed label. The default is Overstrike.
In Overstrike mode, each failed label prints with the Overstrike
pattern and the form retries until the Label Retry count is
exhausted. At this time, the error message “RFID Error: Check
System” displays. The failed label will not be reprinted.
In Stop mode, when a tag fails to be programmed the printer will
halt and display the error message “RFID Error: Check Media.” The
label will be discarded and reprinting of the label (if desired) must
be initiated from the host. When the error is cleared, the label with
the failed tag moves forward until the next label is in position to be
printed.
In None mode, no specific action is taken when a tag fails to be
programmed.
Label Retry
This menu item allows the user to specify the number of label
retries that the RFID UHF encoder will attempt before declaring a
fault indicating a problem with the RFID UHF encoder, the
assembly antenna, the printer setup, or the label stock. Label Retry
only applies when the Error Handling mode is Overstrike. The
default is 5.
In the Overstrike mode, each failed label prints with the Overstrike
pattern and the form retries until the label retry count is exhausted.
At this time, the error message “RFID Error: Check System”
displays. The failed label will not be reprinted.