Filter
Top Products
QUICK SETUP Submenus
43
after a specified number of labels have been printed using a
software cut command. It cuts continuous roll paper, labels, or
tag stock.
NOTE: This feature is currently not supported using the RFID UHF
encoder.
• Continuous. Printer prints on the media and sends it out the
front.
The default is Tear-Off Strip.
Paper Feed Shift
Represents the distance to advance a label (+ shift) or pull back
(– shift) when the Tear-Off Strip, Tear-Off, Peel-Off, or Cut Media
Handling option is enabled. The allowable range is -0.50 inches to
the current Label Length value setting up to a maximum of 12.80
inches in 0.01 inch increments.
The default is 0.00 inches.
Label Length
In most applications, the user-selected Label Length will match the
physical
label length. Physical label length is the actual label length
of the media installed. Following is a list of different media types:
• Die-cut labels – measurable length of the removable label
(leading edge to trailing edge). This does not include the
liner material or gap.
• Tag Stock with notches or holes – measurable length from
the trailing edge of one notch or hole to the trailing edge of
the next notch or hole.
• Tag Stock with black marks on the underside – measurable
length from the leading edge of one black mark to the
leading edge of the next black mark.
• Continuous media (no label length indicators) –
measurable length should be within +
1-2% of the Label
Length value entered.