Filter
Top Products
Chapter 2 QUICK SETUP Menu
42
Label Width
The allowable range in inches is 00.1 to the maximum print width of
the printer. The allowable range in millimeters is 2.5 to the
maximum width of the printer.
Ver Image Shift
Specifies the amount to shift an image up (-) or down (+) for precise
positioning on the label. The actual height of the image is not
affected by this parameter. The allowable range is -1.00 inches to
the current Label Length value setting, up to a maximum of 12.80
inches in 0.01 inch increments.
The default value is 0.00 inches.
Hor Image Shift
Specifies the amount to shift an image left (-) or right (+) for precise
positioning on the label. The actual width of the image is not
affected by this parameter. The allowable range is -1.00 through
+1.00 inches in 0.01 inch increments, displayed as
xx
/100.
The default value is 0.00 inches.
Orientation
Specifies the image orientation to be used when printing the label.
• Portrait. The default. Portrait refers to vertical page orientation,
where the height of a page is greater than its width. The top
edge of the image is parallel to the leading edge of the media.
The following example is viewed from the front of the printer.
4”
FEED
6”
The top edge of
the image is
parallel to the
leading edge of
the media.
Leading Edge