Filter
Top Products
Chapter 3 RFID CONTROL Menu
54
Admin User Menu Items
To see these menu items, set Admin User to Enable in the
PRINTER CONTROL menu. (Refer to the
User’s Manual
.)
IMPORTANT
Admin User menu items should only be used for
troubleshooting.
Tag Type
This menu item selects the tag type in use. The default is Alien
Squig 64. Other classes may be added in the future.
IMPORTANT
If you have a T5000e printer, do not use Alien M-TAG 64, Alien
M-TAG 96, or Matrics X2020 96. Only a T5000e SR or SL5000e
printer can program these tag types properly.
RFID Test (This Test Reads A Tag)
This menu item reads the tag in range of the internal RFID antenna
and reports the tag data to the debug port and momentarily displays
it on the control panel’s LCD. It is primarily intended for
development verification by checking that the system is working.
Auto Retry
This menu item selects the number of automatic (internal) retries
that the RFID encoder will attempt on the same tag before declaring
a tag error and performing the Error Handling mode selected
(Overstrike, Stop, or None). The default is 2.
Custom Tag
This menu item enables or disables the Custom Pwr Set, Custom
Tag Len, and Custom Tag Class menu items (custom tag menus).
The default is Disable.
The custom tag menus allow the RFID encoder to work with tag
types that are not listed in the Tag Type menu item.
NOTE: Printronix cannot guarantee the performance of tag types
not certified by Printronix.