Filter
Top Products
Step 3: Install the Disk Drives
7
SATA300 TX4
The SATA300 TX4 supports up to four Serial ATA drives.
1. Install the disk drives into the drive bays of your system.
2. Attach the power cables to the disk drives.
Caution
Use of removable disk drive enclosures other than Promise
Technology's SuperSwap is not supported and may result in
performance loss or other undesired results.
Note
If you are using a Promise SuperSwap 1100 or 4100 enclosure in
your PC:
• Connect the power cables to the SuperSwap enclosure.
• Attach a SMBus cable from the Management Connector on
the SATA300 TX4 card to the Management Connector on the
first enclosure
These actions are described in Chapter 2 of the SuperSwap User
Manual.