Filter
Top Products
Data Editing
4-4 PowerScan
®
7000 Linear Imager
Global Prefix/Suffix — continued
START
MODE BARCODE
Sets up to 20 characters each from the set of ASCII
characters or any hex value from 0 to FF. To config-
ure this feature, scan the “START” bar code above to
place the unit in Programming Mode, then the “Set
Prefix” or “Set Suffix,” followed by the digits from the
Alphanumeric table in
Appendix C, Alpha-Numeric
Pad
representing your desired character(s). Refer-
ence the section,
Example: Setting a Prefix, for
more information. Exit programming mode by scan-
ning the “END” barcode below (scan “END” twice if
less than 20 characters have been selected).
DEFAULT SETTING FOR THIS FEATURE: 00 (None)
Set Prefix
Set Suffix
END