Filter
Top Products
2 - 3
keep parallel interface in fast operation, please adjust in setup
window the switch positions both 1, and 2 to ON leaving the
rest unchanged as factory default setting.
3. Peripheral connection
The peripheral controller is a 6 pin RJ11 jack between the
power connector and the parallel connector. With use of Posiflex
cash drawer cable 20863018001 (CCBLA-180-1) come with cash
drawer, this port can control a Posiflex cash drawer CR3100 or
CR3200 or CR4000 or CR4100. If a Posiflex special split cable
20867023800 (CCBLA-238) is used instead, this port can control
two cash drawers of above models.
When the printer is used as a kitchen printer, please use this
port for kitchen bell connection instead.
4. Power connection
The power connector is a 3 pin jack at the rightmost
position in the connector area. Either a Posiflex supplied power
adaptor or a printer power cable from a Posiflex POS system can
be connected to this connector to supply power for this printer.
During insertion of the power plug, be sure to hear the click to
obtain a firm contact.
CAUTION: Before doing the insertion or extraction of the
power plug, be sure to pull the outer sleeve of the
plug backward to release the internal latch.
Failure to do this could damage the power plug.
Such damage is considered as an artificial
destruction and is not covered by the warranty.