Filter
Top Products
2 - 6
either paper near end sense or paper feed action. It is also noticed
that some market available paper roll has extremely light bobbin,
easily causing the paper roll to go off position when paper feeding
with low remaining paper. In this case, the paper near end sensor
may function abnormally and it would be a good solution to set in
the setup window to have the printer to send busy only when
input buffer is full and not based on every off line signal.
3. Paper cutting
The paper advance after a protective cut is now set to 12
mm. In case the user uses direct cut instead of protective cut to
have something like a logo printed on top of each slip, it is also
highly suggested to print the logo and necessary paper feeding to
make 12 mm paper advance right after each cut to prevent curling
up and jamming of paper front edge inside the paper exit slot.
4. Wall mount application
In wall mount application, the option kit will include screws
plastic cotters and a paper roll shaft. Screws and cotters are to be
inserted to holes drilled on wall and the paper roll shaft should go
through the paper roll and seat in hold on paper roll compartment
wall. The paper near end sensor must be readjusted for wall
mount application as it approaches the paper roll from different
direction for desktop application.