Q-Logic SANBOX2 Switch User Manual


 
59047-03 B Glossary-1
Glossary
AL_PA
Arbitrated Loop Physical Address
Arbitrated Loop
A Fibre Channel topology where ports use
arbitration to establish a point-to-point
circuit.
Arbitrated Loop Physical Address (AL_PA)
A unique one-byte value assigned during
loop initialization to each NL_Port on a
Loop.
Abstract Syntax Notation (ASN.1)
Abstract Syntax Notation number One
(ASN.1) is an international standard that
specifies data used in communication
protocols.
Authentication Trap
Enables or disables the reporting of SNMP
authentication failures. If enabled, a
notification trap is sent to the configured
trap addresses in the event of an
authentication failure. The default value is
False.
BER
Bit Error Rate
Bit Error Rate
The probability that a transmitted bit will be
erroneously received. The BER is
measured by counting the number of bits
in error at the output of a receiver and
dividing by the total number of bits in the
transmission. BER is typically expressed
as a negative power of 10.
Buffer Credit
A measure of port buffer capacity equal to
one frame.
Class 2 Service
A service that multiplexes frames at frame
boundaries to or from one or more
N_Ports wit h acknowledgment provided.
Class 3 Service
A service that multiplexes frames at frame
boundaries to or from one or more
N_Ports without acknowledgment.
Contact
Specifies the name of the contact person
who is to be contacted to respond to trap
events. The default is undefined.
Datagram
A message sent between two
communicating entities for which no
explicit link level acknowledgement is
expected.
Domain ID
User defined name that identifies the
switch in the fabric.
Fabric Management Switch
The switch through which the fabric is
managed.
Flash Memory
Memory on the switch that contains the
chassis control firmware.